The trend nowadays is to do it yourself, and one of the many tasks to do is buy/replace the water pump. That is why it is important to know the relevant facts about them so that you can make the right decision.
First, the price can range from $ 60 to $ 500 or more depending on the quality and features available. The power of the pump, which ranges from 1/6 HP to 1/2 HP, plays an important role in its price. According to the general rule, the weaker the cheaper. The next decision to make is the choice between a foot pump and a submersible pump. Both have advantages and disadvantages. The submersible pump is out of sight (underwater) and therefore quiet. So using the basement area as a living room is a huge plus. Being away from homes, it is much safer if you have small children nearby.
Vertical pumps are less expensive but have a longer life as the submersible pump is permanently located in the water and is therefore prone to failure. Stabilizers have a lifespan of approximately 25 to 30 years, while submarines can only operate for 5 to 15 years. Operating conditions vary so much that manufacturers only offer a one-year limited warranty. Considering repairs, stabilizers are much easier and cheaper to maintain than submarines.
Moving on to the switching device, they come in various types. Circuit breakers are available in mercury, floats, and diaphragms. While other types are less common, be sure to choose one. Automatic switching points on manual switches, as they do not require a person to start or end their operations. This prevents catastrophic flooding or taps from running dry. Even if the water source runs dry, the “dry” hand pump will burn itself out, while the automatic pump will stop once the water level drops below a certain point.
Another important factor is the ability of the pump to carry water. This is more important than HP and is measured in GPM (gallons per minute) or GPH (gallons per hour). This is based primarily on the vertical “lift” measured from the bottom of the tank (where the pump rests) and the highest point of discharge. As the ‘lift’ distance increases, the pump capacity decreases accordingly. Rate the pump’s ability to pass small solids such as twigs and leaves without clogging.
The physical installation of the pump also affects the price. Parts that don’t wear out or wear out quickly are ideal but will add to the price. These include stainless steel, alloy, cast bronze, and epoxy-coated cast iron, which are preferred. Remember to avoid sheet metal. Polypropylene and good plastics are used in all grades of water pumps.
Please note the length of the electrical cable required at the time of purchase. They are typically available in multiples of 5 (up to 25 feet) but have the store repair a new cable if your requirements exceed this length. Extension cords should not be used with pumps.
If your budget allows, you can also buy pumps that run on non-electric fuels. These are useful in emergencies. This, will be a backup pump and will only work when the main pump is overloaded or not working.
The decision to back down or not depends on your condition and circumstances. Whether you need it or not, it is affected by many factors: the electrical supply in your area, the frequency of floods and storms, etc. If you have a well-equipped home with luxurious furnishings, you may want to have a backup, as it will give you more than just keeping your home water-free, it will give you invaluable peace of mind.
More information on water pumps
Water Pump Buying Guide [https://www.yashengineering.in]
[https://www.yashengineering.in]